Battery Life; Belt Clip Installation; Set Up Features; Handset Registration - ClearSounds A50 Guía De Instalación Y Manual De Usuario

Battery Life

Fully charged batteries provided an average talk time of about 4 hours, or standby time of
about 8 days. Talk time & standby time may vary depending on operating conditions.
The life of the NiMH battery is more than one (1) year.

Belt Clip Installation

You may choose to use the optional belt clip provided with your handset
1. To attach, slide the belt clip down onto the grooves. Press the tabs on the belt
clip into the slots to attach.
2. To remove, lift one side of the belt clip with your thumbnail and push back.
A50 Handset
You will need to wait 24 hours after initial charging before setting up any features
listed below.

Handset Registration

1. Make sure the base unit is connected into the AC outlet and phone jack.
2. Press and hold the
the "CH" button on the handset, and the unit will give a confirmation beep, which
means that the code has been set and the handset will show HS-1 (Handset 1)
on the LCD.
3. If you have more than one handset, press the "CH" button on the handset until
you get a beep and the display reads HS-2. Continue the same procedure if
you have a third handset. If not, release the
NOTE: The /PAGE button on the base unit should be kept pressed during the whole
procedure.
1
(Diagram #7) – Install and remove the belt clip

Set up Features

/PAGE button on the base unit. After 3 seconds, press
(See diagram #7).
/PAGE button from the base.