SCS SOFIA M2V5 Manual De Instalacion Y Uso página 15

ATTACHING AND CONNECTING THE ELEMENTS
1
Attaching
1) Attach the exterior camera at a height of 1.5 metres mounted on a flat wall.
2) First fit the rear support. Finish by tightening the screw at the bottom of the panel.
3) Connect the camera wire (as shown in the diagram below) and insert the camera onto
its support. Do not set up the camera where it is in direct contact with the rain or sun.
After installing and testing, place a clear silicon seal on the top and sides of the exterior
camera (not on the bottom) to avoid any risk of infiltration.
4) Attach the rear support of the monitor (at a height of 1.5 metres on a flat wall).
5) Connect the wires and insert the monitor onto its support.
WIRE SECTION :
Monitor-camera link
From 0 to 15 metres: use the cable provided.
Extend it if necessary by a maximum of 50
metres with 0.75mm² cable.
CABLING DIAGRAM :
MONITOR
MONITEUR V5
ADAPTATEUR
18 VOLTS
2
Ringing volume setting
4
3
2
1
-
+
ENGLISH
3
Monitor - automatic opener or lock link
From 0 to 10 metres: use RVV2 *1mm²
cable.
CAMERA
CAMERA M2
2
6 5 4 3 1
12V700mA
SERRURE OU
GÂCHE
EN OPTION
4
Transformer
red
black
MONITOR
1
2
3
5
MONITOR
+
-
Camera
2
1