Proxxon MICROMOT 50/E Manual De Instrucciones página 11

PrOXXOn - Micromot 50/e
GB
translation of the Original
Operating instructions
Warning!
Read all safety warnings and in-
structions. Failure to follow all
safety warnings and instructions listed below
may result in electric shock, fire and/or serious
injury.
KEEP ALL SAFETY WARNINGS AND IN-
STRUCTIONS FOR THE FUTURE !
safety warnings common for grind-
ing, sanding, wire brushing, polish-
ing, carving or abrasive cutting-off
operations:
a) this power tool is intended to function
as a grinder, sander, wire brush, pol-
isher, carving or cut-off tool. read all
safety warnings, instructions, illustra-
tions and specifications provided with
this power tool. Failure to follow all in-
structions listed below may result in electric
shock, fire and/or serious injury.
c) Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because
the accessory can be attached to your
power tool, it does not assure safe opera-
tion.
d) the rated speed of the grinding acces-
sories must be at least equal to the max-
imum speed marked on the power tool.
Grinding accessories running faster than
their rated speed can break and fly apart.
e) the outside diameter and the thickness
of your accessory must be within the ca-
pacity rating of your power tool. Incor-
rectly sized accessories cannot be ade-
quately controlled.
f) the arbour size of wheels, sanding
drums or any other accessory must
properly fit the spindle or collet of the
power tool. Accessories that do not match
the mounting hardware of the power tool
will run out of balance, vibrate excessively
and may cause loss of control.
g) Mandrel mounted
drums, cutters or other accessories
must be fully inserted into the collet or
chuck. If the mandrel is insufficiently held
and/or the overhang of the wheel is too
long, the mounted wheel may become
loose and be ejected at high velocity.
h) Do not use a damaged accessory. before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
sanding drum for cracks, tear or excess
wear, wire brush for loose or cracked
wires. if power tool or accessory is
dropped, inspect for damage or install
an undamaged accessory. after inspect-
ing and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load
speed for one minute. Damaged acces-
sories will normally break apart during this
test time.
i) Wear personal protective equipment. De-
pending on application, use face shield,
safety goggles or safety glasses. as ap-
propriate, wear dust mask, hearing pro-
tectors, gloves and workshop apron ca-
pable of stopping small abrasive or
workpiece fragments. The eye protection
must be capable of stopping flying debris
generated by various operations. The dust
mask or respirator must be capable of filtrat-
ing particles generated by your operation.
Prolonged exposure to high intensity noise
may cause hearing loss.
j) Keep bystanders a safe distance away
from work area. anyone entering the
work area must wear personal protective
equipment. Fragments of workpiece or of
a broken accessory may fly away and
cause injury beyond immediate area of op-
eration.
wheels, sanding
- 11 -