Unit Description; Initial Use - Medel 95160 Instrucciones Para El Uso

5. Unit description

1. Base device
2. ON/OFF button
4
3. Water tank
4. Adjustable nozzle
5. Water tank opening
6. Mains plug
7. Measuring jug
3
2
1

6. Initial use

• Place the device on a flat, secure, even and water-resistant
surface or table. Under no circumstances should you hold the
device in your hand during operation.
Important
• Only operate the device with distilled water! Do not use tap
water, as this can cause the build-up of limescale in the device
and impair its functionality and service life. Do not use any oils,
herbs or other flavouring agents instead of water.
• Fill the supplied measuring jug with distilled water.
• Remove the tank and open the screwed plug.
• Using the measuring jug, pour the distilled water slowly and
carefully into the water tank until it at least reaches the "min"
level but no further than the "max" mark.When filled to the
maximum level, the amount of water is sufficient for a treatment
lasting approximately 15 minutes. Close the water tank securely
with the screwed plug.
100133_MEDEL BD IONIC SAUNA 95160_USER MANUAL_REV.01_05..06.2017.indd 12-13
5
6
7
150mL
75mL
Distilled water
12
• Insert the water tank back into the device until it audibly clicks
into place.
• Adjust the angle of the nozzle to the required height.
Important
Do not adjust the nozzle when the device is in use! You could
sustain burn injuries to the hand.
• Wash your face with a damp cloth before using the device.
7. Operation
Do not use the ionic facial sauna for more than 15 minutes per day. It is recommended that two to
three treatments are performed per week.
After you have made the necessary preparations described in "Section 6. Initial use", you may start
the treatment.
To start the treatment, carry out the following steps:
• Connect the mains plug to the socket and press the ON/OFF
button.
The indicator lamp begins to light up blue and the ion function
is activated. The device starts to heat the distilled water. After
approximately 30 seconds, steam begins to flow from the nozzle.
After approximately 1 minute, the steam is strong enough and you
can begin the treatment.
• By pressing the ON/OFF button again, the indicator lamp lights up
red and the ion function is deactivated.
• Move your face slowly towards the flow of steam so that the steam
covers your entire face. The steam should feel pleasant and not too
hot. If you feel the steam is too hot, move further away from the
nozzle to prevent burn injuries.
Warning
Ensure that your face does not get closer than 25 cm to the nozzle.
Otherwise there is a danger of your facial skin becoming red or
sustaining burn injuries.
13
05/06/2017 14:15:02