CAME ZL180 Repuestos Originales página 10

Gearmotors connection options
The ZL180 is calibrated to the F7024N or A3024N commands for gate leaves of up to 3 meters.
To command A5024N models (with gate leaves of over 3 m ) and reduce peripheral speed, do the following:
a) - Set dip switches 1 and 6 to ON (and dip switches 2, 3, 4, 5 to OFF)
b) - press CH1: the red PROG led will start to blink
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which depends on the functions selection, see page 12).
N.B.: to return to default, follow the same procedure while pressing CH2.
The control panel is set for 2 gearmotors (2 leaved gates).
With only one gearmotor (one-leaved gates; M2 gearmotor), do the following:
a a ) - Set ) - Set dip switches 4 and 6 to ON dip switches 4 and 6 to ON (and dip switches 1, 2, 3, 5 to OFF); ;
b) - press CH1: the red PROG led will start to blink;
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which depends on the functions selection, see page 12).
N.B.: to return to default, follow the same procedure while pressing CH2.
The microswitches on RA terminals, set the opening stop by default.
However, to activate the opening slowdown, do the following:
a) - Set dip switches 5 and 6 to ON (and dip switches 1, 2, 3, 4 to OFF); ;
b) - press CH2: the red PROG led will start to blink;
c) - when the led stays on (after about 5 seconds) the procedure is complete;
d) - set to the dip switches back to OFF (or to the previous position, which depends on the functions selection, see page 12).
N.B.: to return to default, follow the same procedure while pressing CH1.
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
E
;
B C
;
he following: