Fellowes FORTISHRED 2250C Manual Del Usuario página 3

BASIC SET UP
SHREDDER SET-UP
3
1 2
Open the door Ensure access to a
Place cutter head into
dedicated 15Amp,
top of cabinet, use 2
120V outlet
people
ADVANCED PRODUCT FEATURES
SilentShred™ Technology
SilentShred™ noise quality
shreds without noisy disruptions.
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare
occasions the sensors may become blocked by paper dust causing the motor to run even if
there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry).
TO CLEAN THE SENSORS
1
2
Turn off and unplug Locate Auto-start
shredder infared sensor
TROUBLESHOOTING
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied.
Use Fellowes waste bag 36054.
Safety Shield Indicator: When flashing alternatively with On/Off
open and shredding will stop. To resume shredding, make sure safety shield is closed.
Door Open Indicator: When flashing alternatively with On/Off
To resume shredding, make sure door is closed.
Paper Capacity Indicator: When flashing blue, too much paper is inserted. Shredder will
automatically stop and reverse paper. See Paper Jam section.
R
Overheat Indicator: When flashing alternatively with On/Off
a 10-15 minute cool down period. When
BASIC SHREDDING OPERATION
TO SHRED
1
4
Make sure safety flap Plug in and make
is securely in place sure door is closed
Safety Shield
Electronically controlled shield stops
shredder when opened for advanced safety
3 4
Use thin, long-handled Clean any contamination
brush to clean sensors. from the paper sensors
Make sure brush is clean
and dry
LED, safety shield is
LED, the door is open.
LED, shredder requires
is blue, resume shredding.
2 3
Press ( ) ON to Feed paper straight
activate into paper entry and
release
30
OILING SHREDDER
All cross-cut and micro-cut shredders require oil for peak performance. If not
oiled, a machine may experience diminished sheet capacity, intrusive noise
when shredding and could ultimately stop running. To avoid these problems,
we recommend you oil your shredder each time you empty your waste bin or
every 15-30 minutes of continuous use.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off ( )
and unplug
*Only use a non-aerosol vegetable oil in long nozzle
container such as Fellowes 35250
PAPER JAM
1 2
Gently pull uncut paper
When flashing blue,
from paper entry
too much paper is
15
inserted. Shredder
will automatically stop
and reverse paper
5
4
or
When finished
Do nothing and shredder
shredding set to will automatically shut
( ) OFF
off after 30 minutes of
inactivity
Auto Shut Off
After 30 minutes of inactivity, shredder
automatically turns off for zero energy
consumption
3
2
Press Reverse (R)
*Apply oil
across entry
15
3
If necessary, press
Reverse (R) to run
shredder in reverse
and then pull uncut
paper from shredder
4
Shred 1 sheet of
paper to clear
cutters. Resume
normal shredding
3