Bimar HOTECH S602.EU Folleto De Instrucciones página 11

Fax +32 030 9904733
T
•
he appliance must not be placed directly beneath a plug point.
D
•
o not use this heater with programmers, timers or with any other device that automatically turns
on the appliance, as this could pose a fire risk should the device be covered or positioned
incorrectly.
INSTALLATION
• After unpacking, check the integrity of the appliance; if in doubt, do not use it and contact a
qualified technician. The packaging materials (plastic bags, polystyrene, metal staples, etc.) must
not be left within reach of children, as they constitute possible safety risks and must be disposed of
according to applicable regulations. Warning: any stickers or advertising material applied to the
inlet grid or air outlet or on the base of the unit must be removed before using the appliance.
Warning: the heater must run only if its feet are correctly assembled.
To use the machine, equally assemble the two feet supplied as follows (see figures below):
- check that the power cable is disconnected from the plug point
- Place the device horizontally on a flat, smooth surface.
- Place the feet on the heater by inserting the slots in their hooks and slide them until they lock
into place.
- Use the screws provided to secure them in place.
The device is equipped with an anti-tip system switch which "clicks" when the heater is tilted: it is
therefore normal to hear a noise inside every time you move the heater.
• Before connecting the heater check that the voltage shown on the specifications plate corresponds
to that of the electrical supply, and that the plug is effectively grounded. In the event of
incompatibility between the power supply and the plug, have the plug replaced with a suitable
model by a qualified professional, who should ensure that the size of the cable is suitable for the
power used by the unit. The use of adaptors or extensions is generally not advisable; if it is
necessary to use them, they must comply with safety regulations and the total current (amps) must
not be rated lower than the maximum current of the the appliance.
• The plug point must be easily accessible so as to easily remove the plug in case of an emergency.
• Place the convection heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or flammable material (spray cans) and from materials that
can be deformed by heat. Make sure there is 100cm of free space in front of the heater and 50cm
free space on both sides and at the back.
• Do not use this appliance near a bath, a shower or a swimming pool; (to avoid water droplets
falling on the appliance and the appliance falling into the water); if this happens, do not place your
hand in the water but first turn off the power supply by turning off the switch on the electrical
panel, and only then remove the plug from the plug point. Carefully dry both the plug and the
socket before restoring power. Plug into the power point and then continue using the device. If in
doubt consult a qualified professional.
• The surface must be stable, not sloping (as the unit may fall over), heat resistant.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
11 39
/
Assembly page 11/39