Andis TS-1 Manual Del Usuario página 3

A
Cord
Adapter
Inlet
(Not shown)
B
Foil
Foil
Assembly
Assembly
Assembly
Assembly
Lock
Lock
Button
Button
(Not shown)
(Not shown)
4
Dual Foils
Foil Assembly
On/Off Switch
Assembly
Lock Button
(Not shown)
Green
Charging
Indicator Light
Cord Adapter
C
Grasp both
Grasp both
sides of cutter
sides of cutter
and pull up
and pull up
Foil
FAILURE TO CHARGE Assembly
1. Make sure voltage is present at the wall outlet (confirm with an
appliance you know is working).
2. Check to make sure adapter cord is plugged firmly into shaver. Twist
the adapter connector slightly to insure good electrical connection.
If failure to charge still exists, return shaver to Andis or an Andis
Authorized Service Station for examination and repair or replacement.
USE WITH CORD ADAPTER
If the shaver powers OFF while in use, the power cord can be attached
Assembly
to continue use in corded operation (Figure A). When the shaver is
Lock
running with the power cord attached, the green charging indicator
Button
light will remain off, even if the battery is partially or fully discharged. (Not shown)
The shaver will not charge while in use with the cord attached.
This power unit is intended to be correctly orientated in a vertical
or floor mount position.
FOR SHAVING
1. Keep the unit clean and dry at all times.
2. Remove the protective plastic headguard.
3. Check to make sure the outer foils and inner cutters are not
damaged. Replace damaged parts before using. For more
information on replacement parts, contact Andis or the nearest
Andis Authorized Service Station.
4. Ensure that the battery is charged.
5. Wash and dry your skin thoroughly prior to shaving.
6. Slide the ON/OFF switch up to the ON position.
7. Gently stretch the skin of your face with your free hand while moving
the shaver slowly and smoothly against the grain of your beard. Using
short, circular strokes will make the hairs stand out from your face
and make shaving easier. Hold the shaver at a 90 degree angle to
your face while maintaining contact with the foil.
8. In order to achieve the closest shave and avoid unnecessary wear on
the foils, be sure that both foils contact the skin simultaneously
at all times. Holding the shaver at an angle where only one foil
contacts the skin will cause distortion of the foil and may result in
skin irritation.
sides of cutt
and pull up
5