Black and Decker MATRIX BDCMTOSS Manual De Instrucciones página 5

SYmbolS
• The label on your tool may include the following symbols. The symbols and their definitions
are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ..direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
............Read instruction manual before use
................Use proper eye protection
SaVe theSe INStruCtIoNS
FuNCtIoNal deSCrIPtIoN - FIgure a
1. Garden shear hedge trimmer attachment 2. Grass shear blade
4. Blade release button
aSSemblY
daNger:
result in serious personal injury.
WarNINg:
making any adjustments or removing or installing attachments or accessories..
remoVINg the blade - FIgure b
• To remove the blade cover (5) push and hold the blade release button (4) in the direction of
the arrow (fig. B)
• Slide the blade cover (5) backwards and lift it off (fig. B). Remove blade.
FIttINg the blade - FIgure C, d
• To install the blade cover, position blade and garden shear hedge trimmer attachment as
shown in figure C.
• Fit blade onto the pins on the garden shear hedge trimmer attachment as shown in figure C1.
Note:
The retaining magnet (7) will keep blade secured to garden shear hedge trimmer
attachment.
• Place thumb on blade away from cutting area as shown in figure D. Align blade cover tabs
as shown in figure D1.
• Slide blade cover forward until and audible click is heard and the cover is locked into position.
NOTE: Alignment of blade with drive pin and alignment of the back of the blade and the
retaining magnet (7) is required when re-fitting the blade cover.
oPeratINg INStruCtIoNS
daNger:
result in serious personal injury.
WarNINg:
used near water.
WarNINg:
before making any adjustments or removing or installing attachments or accessories.
WarNINg:
CautIoN:
CautIoN:
keeP haNdS aWaY From blade.
to reduce the risk of injury, turn off and remove battery from tool before
keeP haNdS aWaY From blade.
Shock hazard.
to reduce the risk of injury, turn off and remove battery from tool
Never attempt to lock the switch in the on position.
let the tool work at its own pace. do not overload.
blades coast after turn off.
A ...................amperes
W ..................watts
or AC .......alternating current
n o .................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
..................Use proper respiratory protection
..................Use proper hearing protection
5. Blade cover
Under no circumstances should this product be
5
3. Hedge trimmer blade
6. Active lock-off button
Contact with blade will
Contact with blade will