Tabla de contenido
Publicidad
SETTING UP YOUR KEG COOLER
Changing Direction
of the Door "Swing"
WARNING!
Excessive Weight Hazard
Use two or more people to
move and install the keg
cooler.
I M P O R TA N T !
Allow the unit to stand upright
for 1 hour before putting the
unit into operation.
1. Unplug the keg cooler and
place the unit on its back..
2. Remove the kickplate by
removing the three retaining
screws (Fig. E1)
3. Remove the four screws
from the lower support
( Fig.E2 ) and remove the
lower support.
4. Pull the door downward until
it releases from the upper
hinge pin.
Fig. E1
Castor Installation
The locking swivel castors
should be installed in the
front of the unit for easy
access.
IMPORTANT NOTICE: Before proceeding with the configuration
options on this page, remove keg and the CO
from the Keg Cooler. Once complete, allow the unit to stand
upright for 1 hour before putting the unit into operation.
TOOLS REQUIRED: Phillips #2 screwdriver
5. Remove the plastic screw
caps from the top left hand
side and install it on the top
right hand side of the door
frame.
6
Unscrew the upper door
hinge pin (Fig E3) from the
right side of the worktop
and install it on the left side
of the worktop.
Fig. E2
1. Lay the unit on it's back.
2. Using the 16 machine screws
provided, install each of the 4
castors in the threaded holes
located in each corner of the
unit as shown in Fig.A.
13
cylinder (if installed)
2
7. Position the main door on
the cabinet and push up
until the upper hinge pin is
inserted into the top of the
door.
8. Remove the lower support
pin from the lower support
and reposition it as shown
Fig. E3
in Fig. E4).
9.
Reinstall the
lower support pin on
the lower right side of
the door.
10. Make sure to align the door
with 1) the cabinet, and 2)
the lower support pin before
reinstalling the bottom-plate
and its four (4) screws.
11. Reinstall the kick-plate.
Fig. E4
Fig. A
Publicidad
Tabla de contenido
