SOUNDMASTER SCD1900 Manual De Instrucciones página 10

AC Operation
1. Insert one end of the AC power cord to the AC input socket located at the back of the unit.
2. Plug the AC power cord to the AC mains outlet.
3. Press the button once to turn the unit on.
DC (Battery) Operation
1. Ensure the power cord is disconnected from the AC mains and the unit.
2. Installed the batteries (6 X 1.5V C Size) into the battery compartment. Please ensure that
the polarity is correct (see the floor of the battery compartment)!
3. Press the button once to turn the unit on.
Note: To obtain the best performance in DC operation, the use of alkaline batteries is highly
recommended.
Display Backlight
When the unit is switched on (in AC or DC battery operation) the display backlight will be turned
on to full brightness and go to dim after around 10 seconds. Press a key will turn it to full
brightness again for around 10 seconds.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
After about 15 minute without a signal, the device will automatically switch to standby.
The FM telescopic antenna is located at the left side of the unit, you should fully extend and
adjust its position and direction until you find the best reception.
When the unit is powered up and switched to on for the first time, it will automatically enter into
the FM Radio mode. The display will show FM and the frequency.
To select the FM mode during other operation modes, repeatedly press the "Mode" button until
the display shows FM and the frequency.
Automatic Memory Scan (AMS)
During FM operation, press and hold the "Program" button until it starts to scan the entire
frequency band, the found stations will be automatically stored into the preset memories.
Note: Once the AMS is conducted, all previous preset stations in the memory will be overridden.
Automatic Tuning
Press and hold the "Tune +" or "Tune –" button for longer than 2 seconds to scan up or
1.
down the frequency band for stations, and it will automatically stop on the first found station
of sufficient signal strength.
2.
Repeat the above procedure if you want to search for another station.
INSTALLATION
RADIO
2
SCD1900 / English Instruction Manual