Warranty And Repair - Rohde & Schwarz Hameg HZ56-2 Manual

Safety Standards
– BS EN 61010-1
– BS EN 61010-2-032
– BS EN 61010-031
– CSA C22.2 No. 1010.1
– 300 V rms, Category III, Pollution degree 2
Use of the probe on uninsulated conductors is limited to
300 V rms or DC and frequencies below 1 kHz.
AC
EMC Standards
– BS EN 61326: +A1, A2, and A3.

Warranty and Repair

HAMEG instruments are subjected to a strict quality control.
Prior to leaving the factory, each instrument is burnt-in for
10 hours. By intermittent operation during this period almost
all defects are detected. Following the burn-in, each instru-
ment is tested for function and quality, the specifi cations are
checked in all operating modes; the test gear is calibrated to
national standards.
The warranty standards applicable are those of the country
in which the instrument was sold. Reclamations should be
directed to the dealer.
Only valid in EU countries
In order to speed reclamations customers in EU countries
may also contact HAMEG directly. Also, after the warranty
expired, the HAMEG service will be at your disposal for any
repairs.
Return material authorization (RMA):
Prior to returning an instrument to HAMEG ask for a RMA
number either by internet (http://www.hameg.com) or fax. If
you do not have an original shipping carton, you may obtain
one by calling the HAMEG service dept (+49-6182-800-500) or
by sending an email to service@hameg.com.
14
Subject to change without notice