Ecco EC7000-QK Instrucciones De Instalación página 4

Installation instruction of using pedestal base
1. Select suitable position on vehicle and fix the base support. (Figure 5)
2. Fix the monitor to the base support and adjust the view angle.
3. Put on the sun-visor and connect the monitor with the AV and power supply conversion cable (Figure 6)
!
WARNING!
1. Please align the remote control with the remote signal receiver window to operate.
2. Never disassemble the remote control or allow it to drop or get wet.
Stick the base
support onto the
vehicle
Remote Control Opera
Figure 5
22 PIN MALE
Figure 6
1. MUTE
1. MUTE
To mute/unmute the volume
2. POWER
To mute/unmute the volume
Power off/on button
3. MENU
2. POWER
Menu control button
4. UP
Power off/on button
Menu selection up
5. DN
3. MENU
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
6. VOL-
Menu control button
to decrease the volume and switch between values of each sub-menu
7. VOL+
4. UP
To increase volume and switch between values of each sub-menu
8. MODE
Menu selection up
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
9. SEL.
5. DN
Jump key selector. Fast jump to the display mode specified by SYSTEM SETUP
10. P/N
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
PAL/NTSC TV system selector
11. LANG
6. VOL-
Language selection
12. REST
to decrease the volume and switch between values of each sub-menu
To restore factory settings
13. AV
7. VOL+
To go to/leave DVD channel
To increase volume and switch between values of each sub-menu
8. MODE
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
9. SEL.
Jump key selector. Fast jump to the display mode specified by SYSTEM SETUP
10. P/N
PAL/NTSC TV system selector
11. LANG
Language selection
12. REST
To restore factory settings
13. AV
To go to/leave DVD channel
Page 4 of 8