General Safety Instructions - Parkside PDLA 6.3 A1 Traducción Del Manual De Instrucciones Original

Noise emission value
Noise measurement determined in accordance
with ISO 15744. The rated noise level of the tool
is typically:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear hearing protection!
Total vibration value
Vibration values determined in accordance with
ISO 20643 and EN 12096:
Vibration emission value
Uncertainty
NOTE
► The noise emission levels and vibration values
specified in these instructions have been mea-
sured in accordance with the corresponding
standardised measuring procedure and can
be used to make equipment comparisons.
The noise emission levels and vibration values
vary depending on the use of the compressed
air tool and may be higher than the values
specified in these instructions in some cases.
It is easy to underestimate the noise emission
levels and vibration values if the compressed
air tool is used regularly in this manner.
PDLA 6.3 A1
L = 78 dB (A)
pA
K = 3 dB
pA
L = 89 dB (A)
WA
K = 3 dB
WA
a ≤ 1.27 m/s 2
h
K = 0.62 m/s 2
h
WARNING! General safety
instructions
WARNING!
► For multiple hazards: The safety instructions
must be read and understood before setting
up, operating, repairing, maintaining and re-
placing accessories on the pressing machine
and before working near the machine. Failure
to do this can result in serious bodily injury.
■ The pressing machine should only be set up,
adjusted or used by suitably qualified and
trained operators.
■ This pressing machine must not be modified.
Modifications can reduce the effectiveness of
safety measures and increase the risks for the
operator.
■ Do not lose the safety instructions – hand them
to the operator.
■ Never use damaged pressing machines.
■ Machinery must be inspected regularly to
ensure that it is marked with the clearly legible
design values and markings required by this
part of ISO 11148. The employer/user must
contact the manufacturer to obtain replacement
signs if necessary.
GB │ MT │
23 ■