unotec RESOUND Manual De Instrucciones página 8

Manual
Thank you for your interest in our wireless headphones UNOTEC
ReSound.
Installing the receiver
Insert 2 AAA batteries (not supplied) into the side of the headphones.
Installation transmitter
Insert 2 AAA batteries (not supplied) into the lower compartment.
Connect the audio cables (red-white) to an audio source such as
TV-out, music player, DVD, CD, MP4, etc. In the case that the audio
output device is a cable jack adapter cable sumistrado use as shown
in Figure 1. To improve reception unroll emitter cable so that it acts as
an antenna.
Wireless function
1) After installing the receiver and connected to an audio source (re-
member to plug into an outlet and not an audio input) place the button
on the transmitter WIRELESS EARPHONE position. A red light should
turn on the transmitter.
2) Turn the volume button on the headset until it clicks and the red indi-
cator light. Then press the RESET button once. This places the receive
frequency at the beginning of the band. Now press SCAN key once to
tune the frequency of the same issuer.
Wireless Chat
1) Connect the power adapter to the transmitter (Figure 2) and the other
end to the audio output of the PC. In turn connect the cable jack-jack
output microphone transmitter to the PC microphone
2) Place the transmitter with the microphone facing you (Figure 3) and
place the transmitter button on the AUDIO CHAT position. The red light
will come on.
3) Turn the volume button on the headset until it clicks and the red
indicator light. RESET and then press the SCAN button to tune in the
same fecuencia the issuer.
Monitor
Place the transmitter in the room or place you want to monitor (listen).
Push the button on the receiver to monitor and the red light will light
emitter. Turn the volume button on the headset until it clicks and the red
indicator light. RESET and then press the SCAN button to tune in the
8 ENGLISH