unotec RESOUND Manual De Instrucciones página 9

same fecuencia the issuer.
Listen to the radio
The headset can be used as radio autoscan independently. To do this
turn the headset and press the SCAN tuning stations to go. When you
reach the end of the press often reset to the beginning again and re-
scan stations.
Wired Headset
The headphones can also work directly connected to operate an audio
source via the cable jack-jack (Figure 4). In this case the headphone
volume has no effect (fixed) since the volume depends on the audio
source.
Off
When not using the unit set the transmitter button to OFF and turn the
headphone volume to turn them off. In both cases the red light should
turn off. Remove the batteries if you will be a long period of time without
using the device (both sender and receiver).
Technical Specifications
Transmitter: Frequency: 86 plus / minus 0.5MHz. Modulation: FM.
Distance: up to 8 meters. Power 2 x AAA batteries.
Receiver: Frequency: 0.5MHz 86 or so. Modulation: FM. Distortion less
than 2%. Food 2xAAA batteries.
Tips
To improve reception unroll emitter cable to act as an antenna. If the
sound is distorted or too loud volume setting audio source to a smaller
volume and increase the headset. This improves the sound quality.
Replace the batteries if you notice any of the following problems: 1) The
red indicator is too light emitter 2) The reception is low. 3) The volume
is low and the sound is distorted. It is possible that the proximity of
devices that emit frequencies distort the reception.
ENGLISH 9