Quasar HQ-2101SH Instrucciones De Uso página 2

1
Please observe these following safety precautions when using
your air conditioner.
• Failure or negligence in observing these safety precautions
could cause fire, electrical shock or personal injury.
This symbol (with a white background) denotes
an action that is PROHIBITED.
These symbols (with a blue background) denote
actions that are COMPULSORY.
INSTALLATION PRECAUTIONS
• Due to the weight of this product, we recommend that
you have a helper to assist in the installation. To avoid
injury, use the proper method of lifting. Avoid any sharp
edges.
• Make sure the window frame to be used can properly
support this product.
• This product must be installed in accordance with all local
codes and ordinances.
• Do not install the unit in places where inflammable gas,
fumes or soot may be generated.
OPERATION PRECAUTIONS
• Operate your air conditioner from a stable 115 volt AC
supply.
• Plug into a separate 15 amp grounded outlet only.
• Use of extension cords
Avoid using extension cords. If there are no alternatives,
ensure that the cord is a UL listed 3-wire grounding type,
rated 125 volts with a minimum current-carrying rating of
15 amps, number 14 or heavier wire.
• Use a 15 amp time delay fuse or a circuit breaker.
• Do not switch off by unplugging the power plug while it is
operating. Press the OFF/ON pad to "OFF" before
unplugging.
POWER SUPPLY
Time Delay Fuse : 15 Amps
Rated Voltage : 115V
2
INSTALLATION BOX CONTENTS
Sealer 50 g
(1.8 oz) (Putty)
Type A
screws
Type A screw
Left side expandable panel
• Line Cord Plug
• Socket Type
Top sealing
Window sash
ribbon
sealing ribbon
Window sash
foam seal
Top
angle
Type B
screws
Type A
screws
OPERATION PRECAUTIONS
This sign warns of risk of death or serious injury.
WARNING
• Do not modify the length of the power cord or use an
extension cord.
• Do not touch or operate with wet hands. Do not modify
or damage the cord.
• Do not turn on the unit by inserting the power plug. Do
not switch off the unit by pulling out the power plug.
• Avoid an extended period of direct airflow.
• Do not insert sticks, fingers or other objects into the unit.
• Do not try to repair the unit yourself.
• Plug in properly before operating and use a specified
power cord.
• If abnormal conditions (burnt smell, etc) occur, switch off
and remove the power plug.
This sign warns of injury or damage to property.
CAUTION
• Do not use the unit for other purposes, than its intended
use.
• Do not remove the power plug by pulling the cord.
• Do not block the air intake and outlet vanes.
• Do not splash or direct water at the unit.
• Do not expose the unit to direct sunlight during operation.
• Do not operate the unit without the air filter installed or
when the front intake grille has been removed.
• Do not place any objects on the unit.
• Do not operate any combustion equipment near the unit's
airflow area.
• Switch off the breaker and remove the power plug from
the socket if the unit will not be operated for a long period.
• Pay attention to any damages on the unit caused by
extensive usage.
• Ventilate the room occasionally where the unit is installed.
• Remove the power plug when cleaning the unit.
SCREW FURNISHED
Type A
Side
(Qty 6)
sealing
ribbon
Type A Wood
screw
Screw
SUGGESTED TOOL LIST
Type C
screws
Right side
expandable
panel
Type B Type C
(Qty 5) (Qty 6)
Machine Tapping
Screw Screw
Medium sized
screwdriver (#2
Phillips)
Tape Measure
Pencil
Level
Knife or
Scissor