Setting The Cross Section; Performing A Stripping Test; Setting The Stripping Length; Setting The Draw-Off Length - Weidmuller Power Stripper 6.0 Manual De Instrucciones Original

Setting up the machine

5.2 Setting the cross section

The cross section is automatically set on the Power Strip-
per ... auto models.
The cross section must be manually set on the Power
Stripper 6.0 and Power Stripper 16 models.
Figure 5.3 Setting the cross section
► Rotate the control knob until the correct value is shown
on the display.
► Insert the wire until it is stripped.
.
A minor adjustment is required depending on the
condition of the wire.
Only on the Power Stripper 6.0: Insert the addi-
tional funnel into the insertion funnel with wire
cross sections of 0.05 – 0.34 mm².

5.3 Performing a stripping test

Each time the material to be processed has been changed,
a stripping test must be conducted.
► Switch on the mains switch.
► Insert a wire for stripping.
► Check the result:
– Is all the stranded wire undamaged?
– Has stripping been performed straight and evenly?
26

5.4 Setting the stripping length

Figure 5.4 Setting the stripping length
► Move the locking knob (1) in an anti-clockwise direction
to release it.
► Rotate the control knob until the correct value is shown
on the display.
► Move the locking knob (1) in a clockwise direction to
lock it again.

5.5 Setting the draw-off length

Figure 5.5 Setting the draw-off length
► Move the locking knob (1) in an anti-clockwise direction
to release it.
► Rotate the control knob until the correct value is shown
on the display.
► Move the locking knob (1) in a clockwise direction to
lock it again.
1
1
2562260000/01/10.2017