KEENCUT JAVELIN Instrucciones página 4

3 Maintenance 3
Do not use oil or spirits to lubricate or clean the Javelin/Practik,
some of the plastic components and bearings may be damaged.
Cleaning and lubrication
It is good practice to keep a dust sheet over the Javelin/Practik if it is not to be used for
extended periods. In any event regularly clean it with a dry cloth, to remove any
stubborn stains use a cloth dampened with a little water/detergent.
Should the cutting head slideway require lubrication use a silicon spray or impregnated
sponge.
Cutting Head Bearings
The bearings that control the sliding motion of the cutting head are manufactured from a
high grade polymer and under normal use will last for an extremely long time. As they
settle into position you may find a slight amount of side play, this can be removed by
tightening the two adjustment screws.
Should you require any advice or technical information please contact your
distributor or Keencut direct.