Optika Italy OPTIKAM PRO 5LT Manual De Instrucciones página 2

Installation of camera drivers and software
Operating system requirements: Windows XP, Windows Vista ,Windows 7 or Windows 8. If your PC is Windows
XP : before the intallation of your Camera please check whether is Service Pack2 or not, should not please
update your XP from the Microsoft web site. If your PC has got a USB less than 2.0 there may be some prob-
lems in capturing image from the camera due to the transmission not as fast enough.
1. please insert your CD and chose the folder \Optika Vision Pro\
please select the \camera drivers\ folder.
run vcredist_x32_bit.exe or vcredist_x64_bit.exe accordingly to your Windows PC characteristics.
run optikam_pro_plus_x32_bit.exe or optikam_pro_plus_x64_bit.exe accordingly to your Windows PC
characteristics.
now please select the \ovp_4_5\ folder and run the setup.exe
2. The installer may show warnings about missing Windows certification, ignore such warnings and select
"Continue". Note: do NOT cancel the installation.
3. Then Optika Vision Pro is installed.
4. At the end of the installation process restart the PC if requested.
You will find on your Desktop some Icons which call from the just installed Optika software, at the same
time all these icons will appear in the Start-programs-menu.
5. Plug-in the Camera in your PC, the camera will be identified and Windows will recognize the driver which
has just been downloaded from the CD.
Note: it is not necessary to REinsert the CD again.
Then ignore any message about Windows compatibility and select "Continue" .
Note: do NOT cancel the installation.
6. At the end of the identification process, plug-off your Camera and try to plug-in it again, for checking if the
Driver was installed well no Windows error messages should appear.
Should any error message appear on your PC, you will find a \Troubleshooting\ folder on your CD which
shows how to recover the PC from the problems which Windows could give.
Some notes
You should know that your Windows PC needs to install a Driver before capturing images from the Camera,
when the CD installs the Driver it won't be ready to be used at once, infact Windows needs to recognize the
camera before, and then it will finally put the Driver in the right \driver-folder\.
Note that in any PC there are couples of USB ports, should you connect only the Camera in a couple of port is
better because you'll get a faster comunication.
Often a PC has some ports on the front and some on the back, well, the ports on the back are usually faster.
Page 2