Optika Italy OPTIKAM PRO 5LT Manual De Instrucciones página 3

If you connect the Camera into another USB port Windows needs to recognize its Driver again even if it has al-
redy done this operation for the first USB port.
Generally, every time you use a pheriferal device and after connect your Camera then windows needs to recog-
nize the Driver again.
It may happen sometimes that Windows doesn't recognize a Camera using one of your PC USB port and no
problem with another one.
To prevent any installation problem we have put on the CD all the software in a specific \folder\ which has the
same name.
How to test your Camera
For checking if your Camera works well is not necessary put it into the Microscope, it's enough to connect into
the USB port, run Optika Vision Pro using the icon on your Desktop and check whether you can see a NOT black
image.
What is your Driver
For Optikam Pro5 Camera the driver is :
Optika 519cu
Using Emamcapture you have to tell the program how is the the Driver by selecting "driver".
Using Optika Vision Pro you don't have to tell the program how is the the Driver because it will be automatically
recognized.
Getting started with Optika Vision Pro, a very complete measuring and documen-
tation software.
Run Optika Vision Pro by selecting "Start", "Programs", "Optika Microscopes".
You can see the live image from the Camera, and you can now choose the right CCD exposure time, the gain,
the colour gain, the white balance or the Gamma, in order to see the image in many different modes !
By selecting on the "camera" icon you can fix the current image in order to manipulate it by the software.
As you can see there are many measuring options on the panel: make a calibration, take segments, areas,
pherimeter measures, angles, ecc..
About how they work you can take a look at the manual on the Help menu or at the same into the CD.
Page 3