Batteries Replacement - Stafer 592TX500 Manual Del Usuario

is switch on, it indicates that the first additional
command is activated, if the point is switch off, the first additional command is
deactivated.
- Release the "SELECT" push-button and carry out a transmission.
- When the signal is received , the device associated to the channel will save the
new setting of the first additional command.
5.3 Activation/deactivation of the second additional command:
The second additional command is variable according to the device associated
with the channel. For example, if the channel 2 is
associated with a wind-sun device compatible with the transmitter, the second
additional command allows to activate/deactivate the
wind sensor test. It is therefore necessary to follow the associated device "instruc-
tions sheet", to identify the operation carried out by the
second additional command.
To activate/deactivate the second additional command:
- Keep the "SELECT" push- button pressed until the desired channel is selected.
- Holding "STOP" push-button until the symbol "C" appears on the display
(approx. 8 sec.).
- Press the "SELECT" push-button to activate/deactivate the function. If the red
point on the right of the symbol "c" is switch on, it
indicates that the second additional command is activated for that channel, if the
point is switch off, the second additional command is
deactivated for the selected channel.
- Press "STOP" to exit from the programmation menu.
- When the signal is received , the device associated to the channel will save the
new programmation of the second additional
command.

6. BATTERIES REPLACEMENT

WARNING: Explosion danger if the replaced battery is an unsuitable one.
The flat batteries must be disposed in the 592TX500 is fed by 2 batteries CR2032
- 3V each. To replace them it is sufficient to take the transmitter battery panel off.
Replace both the batteries.
592TX500 rev00 9