Bimar PH35-800 Folleto De Instrucciones página 21

Use without programming.
Press 0/I to I: the display shows the room temperature and the symbol of the day (fig.1)
Press and the appliance switches to standby; press again and it starts heating, with
the SSS symbol on the display.
Press ˄ or ˅ to set the room temperature required.
N.B.: at first use or after a long period out of use, the convection heater may emit smells
or smoke for about 15 minutes.
Use with programming.
Press 0/I to I: the display shows the room temperature and the symbol of the day (fig.1)
Press and the appliance switches to standby; press again and it starts heating, with
the SSS symbol on the display.
Press PROG to set the day and time. Press PROG. The 1 symbol (Monday) flashes. Press
the ˄ or ˅ buttons to set the day of the week; press PROG again and the hours and
minutes flash; use the ˄ or ˅ buttons to set them both. When done, press PROG again.
N.B.: If no button is pressed for 10" during this process, programming is interrupted
(the display symbols go out) and the appliance will function with incorrect
programming
.
Press PROG for 3'' during operation to show the weekly programming on the display
(Fig.3): press the ˄ or ˅ buttons to select the day for programming (the corresponding
symbol 1, 2, ....7 will flash).
Press PROG and the hours will flash. Use ˄ or ˅ to select the hours for programming:
7:16 means from 7:00 to 16:00 hours, and the display will show the segments
corresponding to this time interval (Fig.4)
Press PROG and the temperature flashes. Use ˄ or ˅ to select the programming °C
required; 25:17 means 25°C during the "heating" interval and 17°C during the "off"
interval.
Press PROG and the day symbol flashes; program the other days of the week in the
same way. Press the default button ) to regulate the default temperature (15°C) for the
times not set.
N.B.: The local time (day, hours, minutes) must be set before programming, to enable
the appliance to operate with the correct programming.
•
To stop the appliance, press the "
remove the plug from the socket.
During long periods of inactivity, remove the plug from the electric socket.
" button then set the 0/I switch on. 0 and
21