Naxa NPB-250A Manual De Operación página 9

EXTERNAL MEMORY MEDIA OPERATION (USB,MMC/SD)
Prepare the player for external memory media operation
Insert a USB data traveller into the USB port OR insert a MMC/SD card into the card slot;
Repeatedly press SOURCE button to select USB or CARD mode
IMPORTANT NOTE:
This product supports most common MP3 interface but we cannot guarantee 100%, because there
are too many formats that continue changing in the market.
VARIOUS PLAY MODES
SKIPPING TRACKS AND SEARCHING BETWEEN TRACKS
Press SKIP UP button once to skip the current track and play the next track, press this button
continuously to go to corresponding tracks ahead; Press SKIP DOWN button once to skip the
current track and go back to the previous track, press this button continuously to go back to
corresponding tracks at back. Press and hold SKIP buttons to initiate high-rate scanning between
tracks; release one of them to begin playback of music at normal speed.
REPEAT MODES
Press MODE button once in play mode to repeat the current track; the LCD shows the icon for
single track repeat. Press MODE button twice in play mode to repeat tracks on stored on this
storage media (USB/MMC card) as a whole; the LCD shows the icon for all tracks repeat.
Press MODE button thrice to repeat tracks in the current folder as a whole; the LCD shows the
icon for DIR repeat.
INTROSCAN PLAY
Press MODE button for the fourth time in play mode to activate introscan playback immediately;
the player will pick up tracks for playback of the first 10 seconds of each track in a sequential
order after PLAY/PAUSE button is pressed. You may press MODE button once again to exit
introscan play mode and return to normal playback from the track it's arrived at.
RANDOM PLAY
Press MODE button for the fifth time in play to activate random playback immediately; the player
will pick up tracks in a random sequence for playback after PLAY/PAUSE button is pressed. You
may press STOP button to exit random play mode and press PLAY/PAUSE button to resume
normal playback.
AUXILIARY IN
Your player can be used as a power amplifier to playback the programs from portable radio, TV set
or MP3 player or whatever provided this appliance is so designed that audio signal may be
produced through a LINE-OUT jack or the like.
Observe the following steps to connect the player to another appliance:
1. Press STANDBY button once to power on unit.
2. Repeatedly press SOURCE button to select AUX mode.
3. Connect the your device to the player's AUX in jack with an audio cable (not supplied).
4. Power on the your device and begin play.
EN-8