Spypoint CELL-LINK Guia De Inicio Rapido página 7

STARTING YOUR CELL-LINK
1. Open the CELL-LINK door
2. Turn the CELL-LINK ON (ON/OFF switch)
3. All lights flashing – Searching for signal
The signal search can take a few minutes to process. If only 1 bar is flash-
ing, the network test is unsuccessful. Try moving the CELL-LINK (along with
your camera) to another spot in order to maximize signal strength, then
restart the cellular module. This operation might need to be repeated as
the SPYPOINT SIM card and services are powered by multiple providers.
The network modem will maneuver to ensure the strongest signal
strength by searching for the best tower available (cellular network).
4. Solid bars – Signal strength
Once the network test is completed, bars will stabilize showing the signal
strength. Note that signal bars displayed on the CELL-LINK can differ from
those shown on other cellular devices as there is no industry standard or
practice to label DBM values to a specific number of bars.
5. All lights OFF – CELL-LINK ready
Shut the CELL-LINK door. The CELL-LINK has updated its status in the
SPYPOINT app and website with its latest information. The CELL-LINK
is now ready to grab the pictures taken by your trail camera and transmit
them to you via the SPYPOINT app or website upon its next transmission.
Before starting the CELL-LINK, ensure you have successfully
NOTE:
configured your trail camera according to your preferences and
that you have done this by following your camera' s user manual.
HERE ARE THE RECOMMENDED CAMERA SETTINGS FOR
ENSURING OPTIMAL PERFORMANCE OF YOUR CELL-LINK:
•
A low-resolution photo format.
•
Precisely adjusted date and time
•
A delay no shorter than 1 minute between each detection.
•
In time lapse mode, a delay no shorter than 1 minute.
The CELL-LINK doesn't support video transfers. However, if you configure
NOTE:
your camera for having a photo taken before each video, this photo will be
sent out to you from the CELL-LINK.
7