Zoeller 49 Serie Instrucciones De Instalación página 3

RECOMMENDED INSTALLATION FOR ALL APPLICATIONS
requirements.
preferably just above the basin to allow easy removal of the pump for
below cover installation is required use 30-0164 on 1½" pipe, 30-0152
the basin and to prevent accidental injury.
pipe even with the top of the pump. NOTE: THE HOLE MUST ALSO
BE BELOW THE BASIN COVER AND CLEANED PERIODICALLY.
will be visible from this hole during pump run periods.
before starting pump.
All installations must comply with all applicable electrical and plumbing codes, including, but not limited to, National Electrical Code, local, regional, and/or state plumbing
codes, etc. Not intended for use in hazardous locations.
SUGGESTED METHODS OF FLOAT INSTALLATION
On some installations it may be desirable
to install an independent hanger for the
level control switches to avoid possible
hang ups on the pumps, piping, valves,
etc. Float hangers are available from
FM0526 or can be fabricated from stan-
Always refer to
FM0551 and/or
SSPMA recom-
mended sewage
pump installation
and maintenance.
SK292
TYPICAL FLOAT HANGER ON STEEL COVER PITS
PEAGRAVEL
© Copyright 2011 Zoeller Co. All rights reserved.
according to any and all codes.
DEWATERING INSTALLATION SKETCH.
watertight splice.
switches.
NOTE: Double seal pumps offer extra protection from damage caused by
seal failure.
See FM0531,
for alarms, controls
SK290
ACCESS COVER
STANDARD PIPE
FLANGE
PVC OR LIGHT WEIGHT
STAINLESS STEEL PIPE
SK1217
3
NOTE: FOR AUTOMATIC PUMPS, USE
WW1
EFFLUENT
FILTER
TYPICAL FLOAT HANGER ON CONCRETE PITS
OR SEPTIC TANK RISERS
TYPICAL FLOAT HANGER ON CONCRETE PITS
OR SEPTIC TANK RISERS
SK291
10-1457 FLOAT TREE
WITH 3 FLOATS SHOWN
SK1218