Getting Started; Set Up Base Station; Insert Batteries; Sensor Data Transmission - Oregon Scientific WMR200 Manual Del Usuario

Water will pool to the center of the cross when the rain gauge is level.
If water remains on 1-4, the gauge is not horizontal.
If necessary, adjust the level using the screw.
NOTE For best results, ensure the base is horizontal to allow maximum drainage
of any collected rain.

GETTING STARTED

SET UP BASE STATION

NOTE Install batteries matching the polarities (+ / -) in the remote sensor before
installing the base station.
For continuous use, install the AC adapter. The batteries are for back-up use only.
NOTE Make sure the adapter is not obstructed and is easily accessible to the unit.
NOTE The base station and adapter should not be exposed to wet conditions. No
ob ects filled with li uid, such as ases, should be placed on the base station and
adapter.

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+ / -).
3. Press RESET after each battery change.
NOTE Do not use rechargeable batteries. It is recommended that you use alkaline
batteries with this product for longer performance.
NOTE atteries should not be e posed to e cessi e heat such as sunshine or fire.
LOCATION
Weather forecast area
Rainfall / UV / Wind / Outdoor
temperature / humidity area
MEANING
Base station batteries low
Sensor batteries low

SENSOR DATA TRANSMISSION

To search for a sensor:
1. Select desired area to activate.
2. Press and hold CH and MEM.
3. icons will ash for
NOTE Unit will search only for already registered sensors or new sensors reset
within last 30 minutes. To register a new sensor, reset sensor prior to search.
The sensor reception icon in the remote sensor area shows the status:
ICON
TIP The transmission range may vary depending on many factors. You may need to
experiment with various locations to get the best results.

CLOCK

CLOCK RECEPTION

This product is designed to synchronize its clock automatically with a clock signal.
WMR200:
Slide switch to EU / UK to select the desired signal.
- signal within
S - signal within
WMR200A:
WW - signal within k
clock to select ti e one Pacific,
indicates the status of the clock reception signal.
ICON MEANING
Time is synchronized
Receiving signal is strong
Time is not synchronized
Receiving signal is weak
NOTE Reception takes 2-10 minutes. If the signal is weak, it can take up to 24 hours
to get a valid signal.
To enable / disable signal reception:
Press and hold clock area
sound to confir action
NOTE or best reception, the base station should be placed on a at, non- etallic
surface near a window in an upper oor of your ho e The antenna should be placed
away from electrical appliances and not be moved around when searching for a
signal.

MANUALLY SET CLOCK

1. Press clock area to activate.
2. Press SET to toggle between time zone offset, 12/24 hr format, hour, minute,
year, day / month, month, day, time zone.
3. Once in desired setting, press UP or DWN to change the settings.
4. Press:
SET to confir and continue to ne t setting O
touch panel area e cept tool bar to confir
WMR200: Time zone offset sets the clock +/- 23 hours from the received clock signal
time.
WMR200A: Select the ti e one P
Mountain.
NOTE The language options are nglish
and Spanish (S).
7
inutes
DESCRIPTION
Base station is searching for sensor(s)
A channel has been found
Sensor 1 data received
The sensor cannot be found.
k iles of rankfurt, er any
k iles of nthorn, ngland
iles of ort ollins olorado
ountain, entral or astern
to enable / disable signal reception. A beep will
and e it
Pacific, astern, entral or
, er an , rench
anually set
O
, talian ,