Starting And Stopping The Machine - Wacker Neuson PT2A Manual Del Operador

PT2A / PT3A / PT4A
4.6

Starting and Stopping the Machine

Requirements ■ Suction and discharge hoses properly attached and positioned
■ There is fuel in the tank
Perform the procedure below to start the machine.
Starting the
machine
1. Set the fuel valve to the open position (a
Note: If the engine is cold, set the choke lever to the closed position (b
engine is hot, set the choke lever to the open position (b
2. Turn the engine start switch to the ON position (c
3. Move the throttle lever slightly to the left (d
high speed position (d
4. Pull the starter rope (e).
Note: If the oil level in the engine is low, the engine will not start. If this happens,
add oil to the engine. Your engine may be equipped with an oil alert light (f) that will
illuminate while pulling the starter rope.
5. Open the choke (b
6. Set the throttle lever to the high speed position (d
Perform the procedure below to stop the machine.
Stopping the
machine
1. Set the throttle lever to the slow/idle position (d
2. Turn engine start switch to the OFF position (c
3. Set the fuel valve to the closed position (a
wc_tx004594en.fm
a
1
a
2
f
c
1
).
1
) as the engine warms.
1
).
1
b
2
b
1
c
e
2
1
), about 1/3 of the way toward the
2
1
) to reduce engine speed.
3
).
2
).
2
27
Operation
). If the
1
).
2
d
2
d
1
wc_gr012718
).
) to operate the machine.
d
3