Other Messages; Alarms; Alarm Messages - Aqua ECO-WASH Manual De Instrucciones

STANDARD CONSOLE
Control console for eco•wash system
3.12 O
THER MESSAGES
4.0

ALARMS

4.1 A
LARM MESSAGES
During functioning, the console can display the following alarm messages:
Message
Alarm P##!
The product tank of P##
(with levels
pump is empty.
module)
The tank of one of the
Low level alarm! chemical products is
empty.
The autostart mode has
Autostart
selected a program greater
alarm!
than 20.
Water is not passing
No water!
through the flushing kit
Pump Pump ## is not functioning
alarm ## ! correctly.
Maintenance The maintenance alarm
alarm! has triggered.
The calibration alarm has
Calibration alarm!
triggered.
Alarm Communication problems
module x! with module x.
System initialisation
LOADING ERROR
problems.
Problems on a program
Program ERROR!
start.

To disable the buzzer (buzzer) an alarm, press the Enter key for three seconds and if it is off it is also
disabled.
ADSP7000604
Message
Priming The priming has been performed using
in progress the button on the pump.
PC conn. hh:mm The system is not active as connected
<<<<< >>>>> to computer
Meaning
rev. 1.3
Meaning
Solutions
Replace tank or fill it.
Replace tank or fill it.
Check autostart programming.
Check correct electric connection
of the solenoid valve and if water
is present.
Check tube, motor and roller
carrier of the pump.
Call after-sales assistance.
Call after-sales assistance.
Check connection cable and
connection of the RJ11 connector
on the circuit.
Switch the system off and on.
Check autostart programming.
17/09/2015
ALARMS
ENGLISH
Alarm deactivation
Yes, keep the Enter
key pressed.
Yes, keep the Enter
key pressed.
No, eliminate alarm
cause.
No, eliminate alarm
cause.
No, eliminate alarm
cause.
Yes, keep the Enter
key pressed.
Yes, keep the Enter
key pressed.
No, eliminate alarm
cause.
Not possible.
Yes, keep the Enter
key pressed.
20/62