Remote Control; Lcd Display; Getting Start; Power Supply - Oregon Scientific WS903 Manual De Usuario

1. POWER: Turn on/off the unit.
SOR
2. SLEEP: View remaining time; enable sleep function
with diffusing / nature sound / light; set sleep timer.
3. TIMER: View auto timer ON status; enter timer
settings.
4. BRIGHTNESS / -: Toggle high/low LCD brightness;
decrease values of the setting.
5. DIFFUSE: Toggle through selection (ON / REPEAT
ON&OFF 30 seconds/ OFF).
6. LIGHT: Toggle through selection (Red / Orange /
Yellow / Green / Blue / Purple / Loop).
7. SOUND: Toggle through 5 soothing sounds.
8. VOLUME / +: Toggle through 3 sound volumes;
increase values of the setting.
9. CR2025 batteries - already installed

LCD Display

1 2
6
7
3 4 5
9
8
3
1. Sleep mode is ON
2. Auto timer mode is ON
3. Soothing sound is ON
4. Lighting is ON
5. Diffusing is ON
6. Battery low / no battery
7. 24HR clock format
8. AM/PM
9. Clock / settings
GETTING STARTED

POWER SUPPLY

1. Remove the battery insulator before use.
2. Pour maximum 300ml tap water in room tempera-
ture into the water tank.
3. Add few drops of essential oils into the water.
4. Put back the cover.
5. Plug in the power adaptor.
6. Press the infrared remote control on remote control
compartment to take it out.
7. After using the remote control, insert it to the
remote control compartment.
8. Press POWER to turn on the unit.
NOTE Do not use distilled water with this product.
Water temperature should be 15 - 40 ºC.
100% nature essential oil should be used.
Switch off the unit and unplug from the mains before
moving or cleaning the unit.