Continuity.cHeck - Beta 1760/RMS Manual Del Usuario

1 Set the function switch to the Ω position.
2 Insert.the.black.test.lead.plug.into.the.negative.(COM).socket.and.the.red.test.lead.plug.into.
the positive Ω jack.
3 Press the MODE button until "Ω" appears in the display.
4 Touch.the.test.probe.tips.across.the.circuit.or.part.under.test..It.is.best.to.disconnect.one.side.of.
the.part.under.test.so.the.rest.of.the.circuit.will.not.interfere.with.the.resistance.reading.
5 Read.the.resistance.in.the.display..The.display.will.indicate.the.proper.decimal.point,.value.
and.symbol.
CONTINUITY CHECK
WARNING:
To. avoid. electric. shock,. never. measure. continuity. on. circuits. or. wires. that. have. voltage. on.
them.
1 Set.the.range.switch.to.the. ..position.
2 Insert.the.black.lead.plug.into.the.COM.socket.and.the.red.test.lead.plug.into.the.positive.•))).
socket.
3 Press.the.MODE.button.until.". .".appears.in.the.display.
4 Touch.the.test.probe.tips.to.the.circuit.or.wire.you.wish.to.check..
5 If the resistance is less than 30Ω, the audible signal will sound. The display will also show the
actual.resistance.in.ohms