Publicidad
Idiomas disponibles
Idiomas disponibles
3. CLEANING:
Regular cleaning of the striding belt ensures a long product life.
● Warning: The treadmill must be turned off to avoid electrical shocks. The power cord must be
pulled out of the socket, before starting the cleaning or maintenance.
●After each training: Wipe the console and other surfaces with a clean soft and damp cloth to
remove sweat residues.
Caution: Do not use any abrasives or solvents. To avoid damage to the computer, keep any
liquids away. Do not expose the computer to direct sunlight.
●Weekly: To make the cleaning easier it is recommended to use a mat for the treadmill. Shoes
can leave dirt on the striding belt that can fall beneath the treadmill. Clean the mat under the
treadmill once a week.
4. BELT ADJUSTMENT
You may need to adjust the running belt during the first few weeks of use. All running belts are
properly set at the factory. It may stretch of be off center after use. Stretching is normal during the
break-in period.
ADJUSTING THE BELT TENSION:
If the running belt feels as though it is ―slipping‖ or hesitating when you plant you foot
during a run, the tension on the running belt may have to be increased.
TO INCREASE THE RUNNING BELT TENSION:
A. Place 8mm wrench on the left belt tension bolt. Turn the wrench clockwise 1/4 turn to draw the
rear roller and increase the belt tension.
B. Repeat STEP 1 for the right belt tension bolt. You must be sure to turn both bolts the same
number of turns, so the rear roller will stay square relative to the frame.
C. Repeat STEP 1 and STEP 2 until the slipping is eliminated.
D Be careful not to tighten the running belt tension too much as you can create
excessive pressure on the front and rear roller bearings. An excessively tightened running belt
may damage the roller bearings that would result in bearing noise from the front and rear rollers.
Adjusting screw
Screw
Publicidad
