Safety Precautions - Philips SBC LI 805 Modo De Empleo

XP SBC LI 805 24-06-2002 09:06 Pagina 4
ENGLISH
4
Receiver SBC LI 805
Receiver
The Philips SBC LI 805 receiver can be used as receiver for the SBC RU 885
R(adio) F(requency) remote control as well as additional receiver for the
SBC LI 800 Remote Control extender set. When used in conjunction with
the RU 885 you can operate most IR driven equipment (e.g. Hi-Fi sets,
VCRs, Sat-receivers, etc.) from anywhere in your house without actually
seeing the equipment or aiming the remote control at it. For operation with
the LI 800 extender set, see the User Guide of the set.
The RU 885 is able to send RF (radio frequency) signals that go through
walls or, if your equipment is located in a cabinet, through the cabinet door.
When receiving a signal from the RU 885, the receiver re-converts the
RF-signal to a propriate IR signal and sends it to the equipment you wish to
operate.
In case you wish to control equipment in different rooms you can extend
your equipment with more LI 805 receivers.
IR extension cord
The extension cord can be connected if the receiver is located in a cabinet
or if you do not want to place the unit in front of your equipment.The cord
has three IR lights that allow you to operate three devices simultaneously.
Adapter
For connecting the receiver to the mains supply.
To ensure you get the best performance from your receiver please read this
manual carefully.
Important information
Read these instructions. All operating instructions and safety precautions
should be read before using the receiver.

Safety precautions

• Check if the voltage indicated on the type plate of the adapter
corresponds to the local mains voltage before connecting to the mains
power supply.
• The receiver is powered once it is connected to a 230-240 VAC mains
supply. Disconnect the receiver from the mains supply when not in use.