Whalen WSLWFP48-5 Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
19. Attach one handle (KK) to the front side of each door (P) with the
provided handle bolts (LL).
Hardware Used
KK Handle
LL
Handle Bolt
20a. Pick up one door (P) and attach the extended hinge arms to the
hinge bases installed on the lower left side panel (H). Loosen the
bolt on the back of the hinge base for an easy fit. Align and insert
the "U" slot on the hinge arm under the bolt head on the back of
the hinge base. Make sure that both door hinges engage and
function properly. Tighten the bolt on the hinge base to lock the
hinge in place.
20b. Repeat the same procedure to attach the other door (P) at the
opposite side.
20c. Open and close the doors to make sure they are aligned and shut
correctly. If necessary, adjust the screws for a good fit. Refer to
the hinge sticker on the door for adjustment.
20d. Stick the rubber bumpers (QQ) at the outer corners of both doors
(P) where they meet with the partition panels (J and K).
Hardware Used
QQ Rubber Bumper
21. Lift the fireplace insert carefully into the back of the assembled
mantel and center it in the opening. DO NOT drag the insert
across the bottom panel (B) as it may scratch the unit.
19
P
x 2
x 4
20
K
H
P
x 4
QQ
21
R
J
S
S
B
12
ASSEMBLY INSTRUCTIONS
22. Using the pilot holes as a guide, align and attach L-shaped metal
LL braces (MM) to the bottom panel (B) by screwing one washer head
screw (DD) in each.
Hardware Used
DD M3.5 x 15 mm Washer Head Screw
MM
L-Shaped Metal Brace
KK
x 2
23a. Remove the paper backing from the acrylic stopper (PP), then
properly align the acrylic stopper into the cut-out on the acrylic
stopper template on the front of the top panel (A). Press down
on the acrylic stopper to help adhesion.
23b. At the back of top panel (A), grip the heads of plastic tacks with
pliers, with twisting motion pull tacks loose to remove the acrylic
stopper template.
NOTE: You must install the acrylic TV stopper to prevent
TV from tipping when placing your flat panel television on
the top panel.
1
Hardware Used
P
PP
Acrylic Stopper
Electric
Firebox
22
The rubber bumper is
against the firebox
DD
x 2
x 2
MM
23
PP
PP
A
x 1
13
B