Control Panel And Features - Whirlpool 7MWTW1950EW Manual De Uso Y Cuidado

Control Panel and Features

1
1 DEEP FILL
This option adds more water to the cycle, providing a
deeper fill.
2 TEMPERATURE
Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment-label instructions, use the warmest wash
water safe for your fabric.
On some models and cycles, warm and hot water may
■
be cooler than your previous washer.
Even in a cold- and cool-water wash, some warm
■
water may be added to the washer to maintain a
minimum temperature.
3
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
4
SOIL LEVEL
Select the setting most suitable for your load. For heavily
soiled and sturdy fabrics, select Heavy for more wash
time. For lightly soiled and delicate fabrics, select Light for
less wash time. A lighter soil-level setting will help reduce
tangling and wrinkling.
5 EXTRA RINSE
This option can be used to automatically add a second rinse
to most cycles.
6 START/PAUSE BUTTON
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: Hold the Start/Pause button for 3 seconds to cancel
the wash cycle.
7
PROGRESS INDICATOR LIGHTS
The progress indicator lights show the status of a cycle. At
each stage of the process, you may notice sounds or pauses
different from traditional washers.
2
Not all features and options are available on all models.
Appearance may vary.
3
7 6
SENSING FILL
When the START/Pause (Inicio/Pausa) button is pressed,
the washer will fill to an initial water level and begin
sensing to determine the load size. The washer will then
continue filling to the appropriate water level based on
load size and proceed to Wash.
If the lid is opened or the START/Pause (Inicio/Pausa)
button is pressed, the cycle will pause. Closing the lid
and/or pressing the START/Pause button will resume
the cycle. If the cycle remains paused with the lid open
for 10 minutes, the washer will pump out the water.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle.
Wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly (short hum) to move the basket
while filling.
DRAIN/SPIN
The washer spins the load at increasing speeds for proper
water removal based on the selected cycle.
DONE
Once the cycle is complete, this light will come on. For
best results, promptly remove the load.
LID LOCKED
The lid-lock feature allows for higher spin
speeds. When lit, the lid is locked and
cannot be opened without pausing the
cycle. When the light is off, the lid can
be opened.
To open the lid after it has been locked,
press START/Pause (Inicio/Pausa). The
lid will unlock once washer movement
has stopped. This may take several
minutes if the load was spinning at high
speed. Press START/Pause (Inicio/Pausa)
while the lid is closed to resume the cycle.
NOTE: Holding the START/Pause (Inicio/Pausa) button
will cancel the cycle and cause the washer to drain.
Avoid opening the lid during sensing. The sensing process
will start over when the washer is restarted.
4
5
21