Introduction; Control/Display Functions - Cole-Parmer Masterflex I/P 77420-00 Manual De Operación

INTRODUCTION

The Console Drive controls the speed of MASTERFLEX ® I/P ® Pump Heads to provide flow rates from 0.12 to
17 L/min, or 26 L/min with two pump heads.
®
Mount up to 2 MASTERFLEX ® I/P ® EASY-LOAD or Standard Pump Heads or 1 MASTERFLEX High-Performance
®
I/P Pump Head.

CONTROL/DISPLAY FUNCTIONS

Press keys to activate function. Use UP/DOWN ( , ) arrow keys to correct/change a flashing display.
Press any key to enter new values.
F
A B C D E
K H
J I G
A. DOWN ARROW (DECREMENT)—Decrease value of a flashing display.
B. UP ARROW (INCREMENT)—Increase value of a flashing display.
C. FLOW CONTROL—Set flow rate for selected tubing size. To change flow rate, press or arrows. (If pump is
running, its speed will change with new settings.)
D. TOTAL VOLUME—Display cumulative dispensed volume.
E. START/STOP—Start/Stop motor.
F. PRIME—Run pump at full speed to fill or clear lines.
G. DIRECTION—To change motor direction.
H. MODE SELECT—INTERNAL for internal control; mA for remote current control; V for remote voltage control.
I. DISPENSE/COPY—Select dispensed volume, number of copies of a dispensed volume, or the dispense interval.
J. CAL CONTROL—Refine built-in calibration using a measured volume.
K. TUBING SELECT—Select tubing size.
1