Know Your Product; Intended Use; Residual Risks - Ryobi RTS1800 Traducción De Las Instrucciones Originales

Check the tips of the saw blade for damage or abnormal
Scrap the saw blade if damaged, deformed, distorted or
Ensure the saw blade is mounted correctly, tighten the
Fastening screw and nuts shall be tightened using the
Using an extension on the spanner or tightening using
Make sure the blade and flanges are clean and the
Make sure the blade rotates in the correct direction and
does not contact any part of the machine or guarding
turned on so the position of the blade, operation of the
guards with respect to other product parts and work
Never attempt to stop the power tool in motion rapidly
serious accidents can be caused unintentionally in this
Disconnect the power tool from the mains supply before
Pay attention to blade packing and unpacking, it is easy
Use a blade holder or wear gloves when handling a saw
Keep and store the blade in original packaging or other
suitable packaging, keep in dry conditions and away

INTENDED USE

The table saw is designed to be operated by one person for
the purpose of rip and cross cutting wood, up to a maximum
Only blade and riving knife combinations supplied by the
manufacturer of this table saw, for this table saw may be

RESIDUAL RISKS

Even when the table saw is used as prescribed, it is still
The operator should pay particular and additional attention
to these points in order to reduce the risk of serious
Contact with the blade – avoid reaching towards, over
Stability – ensure the product is stable, whenever
Thrown cutting blade tips – wear eye protection at all
produced when working certain types of wood products
Noise levels can vary widely from machine depending
levels, even for a short time, may experience temporary
partial hearing loss and continuous exposure to high

KNOW YOUR PRODUCT

See page 242.
Table insert
Mitre guide
Saw blade
Saw blade guard
Table insert release
Side table extension (RTS1800ES, RTS1800EF)
Fixing holes (secure to work bench or legs)
Depth of cut handle
Saw table
Dust exhaust
Dust port accessory
OPERATION
WARNING
You must read and fully understand all of the warnings
and instructions contained in this manual before applying
Through cutting: Any cutting operation where the saw
For this operation the riving knife should be in the raised
Non through cutting: Any cutting operation where the
saw blade does not protrude beyond the thickness of the
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
English | 5