User Maintenance - Andis HVS-1 Instrucciones De Uso Y Cuidado

(making it inoperable) under abnormal
conditions, such as falling or being immersed
in water. The ALCI shock protection is
equipped with a test and a reset button.
Following are instructions on their use.
TEST BEFORE EACH USE
1. Plug the ALCI shock protection plug into
a 110-120 volt electrical outlet (ordinary
household current). Do not attempt to use
any other electrical outlet.
2. Before attempting to switch the dryer on, perform the following test:
Press the test button, the reset button should pop up. This confirms that
the safety plug is working properly.
3. Now press the reset button and your dryer will be operable and the
power switch of your dryer may be turned on for normal use.
4. If the dryer does not operate properly, it should be either returned to an
Andis authorized service station for examination, or discarded.
HEAT AND FAN SETTINGS
This dryer is equipped with two air speeds and three heat settings. To turn
dryer ON and change air speed, push bottom switch to desired setting.
To change heat setting, push the middle switch to desired setting (Figure B).
COOL SHOT
This dryer is equipped with a cool shot button. To achieve the cool shot of
air, press the cool shot button (Figure B). The cool shot is ideal for locking in
curl for longer lasting style. Just concentrate cool air on desired curl until set.
B
COOL SHOT
COOL
WARM
HEAT SETTINGS
HOT
OFF
FAN SETTINGS LOW
HI
4
A
C
GRILL BACK OF DRYER
WING TABS

USER MAINTENANCE

RESET
This appliance does not require special maintenance, cleaning or
TEST
lubrication. Service only through Andis authorized service stations. To find
an Andis authorized service station near you log on to www.andis.com or
contact our customer service department: 1-800-558-9441 (U.S.) or
1-800-335-4093 (Canada).
Untwist cord before use. After use, re-wrap cord and store unit in a safe
place. Do not wrap cord tightly around appliance. Do not hang the unit by
the power cord.
TO REMOVE AIR INTAKE GRILL
This Andis dryer is equipped with a removable air intake grill. This grill may
be removed for ease of cleaning excess hair and lint that can clog up a hair
dryer. To remove the grill, simply depress the wing tabs on the side of the
grill (Figure C). To clean grill that has been removed from the dryer, take a
small brush and mild cleaning solution and lightly brush away excess lint
and hair. Rinse and dry. Once it is completely dry, snap grill back into place.
CLEANING
• The hair dryer must be unplugged before it is cleaned.
• Clean the external surfaces of the hair dryer with sponge or soft rag
moistened with a mild soap and water solution. Do not use harsh cleaners,
detergents, or solvents.
• Dry the hair dryer thoroughly before use.
• Clean screen with vacuum cleaner.
5