Safety Notes; General Notes; Functions; Notes On Digital Operation - Trix 22777 Manual Del Usuario

Safety Notes

• This locomotive is only to be used with the operating
system it is designed for.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must not be supplied with power never
from more than one power source.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.

General Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html

Functions

• Built-in electronic circuit for operation with a conven-
tional DC power pack (max. ±12 volts), Trix Systems or
NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• The full range of functions is only available under Trix
Systems and under DCC.
• Built-in headlights that change over with the direction of
travel. They can be turned on and off in digital operation.
• Minimum radius for operation is 360 mm/14-3/16".

Notes on digital operation

• The operating instructions for your central unit will give
you exact procedures for setting the different parame-
ters.
• The values set at the factory were selected to guarantee
the best possible running characteristics.
• The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block.
If you want this characteristic, you must do without
conventional DC power operation (CV 29/Bit 2 = 0).
No warranty or damage claims shall be accepted in those cases where parts
neither manufactured nor approved by Trix have been installed in Trix products or
where Trix products have been converted in such a way that the non-Trix parts or
the conversion were causal to the defects and/or damage arising. The burden of
presenting evidence and the burden of proof thereof, that the installation of non-Trix
parts or the conversion in or of Trix products was not causal to the defects and/
or damage arising, is borne by the person and/or company responsible for the
installation and/or conversion, or by the customer.
9