Delay Mode; Utility Mode - VWR SAS Super IAQ Manual Del Usuario

Once the sampling volume has been set, press the 'ENTER' button to confirm.
The display will show the old and new volume.
Press the "Up or "Down" arrows to select the first digit and press 'ENTER' to confirm.
Press the Up or "Down" arrows to select the second digit and press 'ENTER' to confirm.

'DELAY MODE'

With this function it is possible to delay the beginning of the sampling cycle. If a delay has been selected, the
sampling cycle will begin after the selected delay time.
Switch on the instrument and wait until the main screen is displayed:
Press the "Up" or "Down" arrows to reach the:
Press the 'ENTER' button and the delay time is displayed:
Select the desired delay time using the "Up or "Down" arrows. The selectable delay values are 1, 2, 3, 5, 10 or 20
minutes. Press the 'ENTER' button to confirm.
When a delay has been selected, after the "START" button has been pressed, a delay warning message will be
displayed.

'UTILITY MODE'

With this function it is possible to modify all the settings of the air sampler.
The 'UTILITY MODE' is divided into ten sub menus: