How To Reverse The Hinges, Doors And Drawer; How To Replace The Hinges, Doors And Drawer - Kenmore 596.65332600 Guía De Uso Y Cuidado

How to reverse the
hinges, doors and
drawer
1. Perform all steps listed in How to
Remove the Hinges, Doors and
Drawer (page 8).
2. Transfer cabinet
plugs and cabinet
screws to opposite
side of cabinet.
• Remove cabinet
plugs with flat
blade of
screwdriver tip
wrapped in
masking tape.
• Remove center mullion screws with
a 5 " hex head driver.
⁄
16
• For freezer door only: Remove
bottom mullion screws with
head driver.
IMPORTANT: When working directly on
doors, place doors on a nonabrasive
surface protected by towels or rugs to
avoid damage to door finish.
3. Transfer door stops from bottom edge
of fresh food door and freezer door
(some models) to
opposite side of
door edge.
• Use a Phillips
screwdriver for
removal and installation.
4. See How to Install and Remove
Handles to remove and reinstall
handles (page 7).
5. Proceed to How to Replace the
Hinges, Doors and Drawer to mount
doors.
All manuals and user guides at all-guides.com
How to replace the
hinges, doors and
drawer
1. Install hinge assemblies.
• Install top hinge loosely with
head screws.
• Install center hinge with Phillips
screws.
• Install bottom hinge with
head screws.
2. Insert bottom
hinge pin
(some models).
• Locate bottom
hinge hole
closest to
outside edge
of cabinet,
and insert bottom hinge pin.
3 " hex
⁄
8
Replace any door shims, if present.
3. Replace toe grille and bracket
cover(s). See markings on inside of
toe grille to insure proper placement.
• Snap bottom portion into place
first. Press down on top part of grille
until top portion snaps into place.
4. For freezer door
only: Place hinge
side of freezer
door on bottom
hinge pin. Hold
freezer door
upright while installing center hinge
pin with 5 " hex head driver.
⁄
16
• Replace any applicable door shims.
• Make sure the hinge pin is installed
tightly.
For freezer drawer only: Install
center hinge pin with
driver.
• Replace any applicable door shims.
• Make sure the hinge pin is installed
tightly.
5. Place hinge side of refrigerator door
on center hinge pin.
6. While holding
refrigerator door
upright, tighten
down top hinge
with
driver and replace
hinge cover (some
models).
5 " hex
⁄
16
PULLOUT DRAWER
1. Pull both rails out to full extension.
3 " hex
⁄
8
2. Hook door supports into rail tabs, as
illustrated, and lower door into final
position.
3. With drawer pulled out to full
extension, insert lower basket by
aligning tabs on both side of lower
basket with notches in rail assembly.
4. Slide upper basket into unit. Make
sure that rear of basket hooks behind
rail catch.
5 " hex head
⁄
16
5 " hex head
⁄
16
9