Klein Tools Probe-Pro VDV500-123 Manual De Instrucciones página 5

VERIFYING TONED PAIRS (FIG. 2)
1. Connect tone generator (VDV500-063 Toner-Pro recommended, sold
seperately) to the cable to be traced, following the tone generator's
instructions.
2. On the other end of the cable, remove approximately 2 mm (3/32") of the
outer jacket of each of the wires believed to be the toned pair.
3. Insert the wire connected to the positive test clip of the tone generator to
the "+" (Positive) Terminal
clip of the tone generator to the "-" (Negative) Terminal
terminals, press their respective Terminal Release buttons
wire(s) and release (FIG. 2). The Verification Indicator
when the correct pair is inserted.
FIG. 2
TRACING NON-PAIRED WIRES (FIG. 3)
1. Connect tone generator (VDV500-063 Toner-Pro recommended, sold
seperately) to the wires to be traced, following the tone generator's
instructions.
2. Turn the Probe-Pro on by pressing the Power On/Off button
3. At the far end of the cable, spread the wires at least 2" (51 mm) apart, if
possible.
4. Use the Probe-Pro to scan the cable's wire pairs. Move the Probe-Pro's
tip slowly across the wires. The Probe-Pro's volume will increase as it
P1
approaches the toned wire.
FIG. 3
VDV500-063
(sold seperately)
OPERATING INSTRUCTIONS
, and the wire curently in the negative test
P12
Press
(51 mm)
. To access the
P11
, insert the
P13
will illuminate
P14
.
P5
2"
5