Activating Live Mode; Night Exposures - Lidl Service WK5A3 Instrucciones De Uso

Activating live mode

Live mode is the standard operating mode of the camera. In this
mode, recordings are triggered via the motion sensors
live mode, slide the operating mode selector switch
position. After fifteen seconds the red LED of the standby indicator
will go off. Then the camera will start to operate independently and
will go into standby mode. As soon as any wild or other animals
or people enter the detection range of the central sensor zone, the
camera will start capturing photos and/or videos (depending on
the configuration).
If wild animals enter the detection range of the side motion sensors
these will detect the motion and activate the camera. If the wild
animals continue to move in front of the front motion sensor
camera will continue taking photos/videos. When the wild animals
leave the detection range of the side motion sensors
switches off and goes back into standby mode.

Night exposures

During night exposures the infrared LEDs
camera provide the required light for making recordings possible.
The LEDs emit light over a wide angle. This makes it possible to make
night recordings at a distance of about 3 m to 20 m without overex-
posing the subject. However, reflective objects such as traffic signs
can cause overexposure if they are located within the recording range.
Please note that night exposures are made in black and white.
│ GB │ IE
■ 74
6
to the "ON"
18
, the camera
7
on the front of the
1
, . To set
7
2
,
7
, the
6
WK 5 A3