Troubleshooting - Hoover CH90100 Manual De Instrucciones

MAINTENANCE INSTRUCTIONS
REMOVING/REPLACING THE ANTI-STATIC STRAP:
The anti-static strap should not be worn while performing maintenance.
TO REMOVE THE STRAP:
1. Turn electrostatic function off and remove the battery from the unit.
2. Use a T15 bit (not included) to remove the two cover screws.
3. Remove the cover.
4. Detach the snap connector.
TO REPLACE THE STRAP:
1. Attach the strap to the unit by attaching the snap connector to the snap fastener.
2. Reinstall the cover.
3. Tighten the cover screws.

TROUBLESHOOTING

If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped
into water, call customer service at 1-888-768-2014 prior to continuing use.
This product contains no serviceable parts. Call 1-888-768-2014 for Customer Service.
Problem Possible Cause
Unit has trouble priming/ Pump has lost it's prime. Insert the largest micron nozzle
doesn't spray when tank
is filled.
Unit sprays improperly. Nozzle is clogged, or
fluid in tank is low.
Nozzle is loose.
Unit is "spitting." Liquid in tank is too
thick.
Spray is weak. Solution is too thick.
Unit runs for a short Battery needs charging.
period then shuts off.
Solution is too thick.
Solution
tip and pull the spray trigger. Once
spray begins, replace the nozzle
with your intended nozzle tip size.
Try a different nozzle. If that
solves the issue then clean out the
previous nozzle. Make sure there is
sufficient fluid in the tank.
Ensure the nozzle tip is affixed
securely in the nozzle by tightening
the castle nut with the included
t-handle nozzle tool.
Empty the tank, clean the tank,
then try again. Make sure that
all chemicals/liquids used in the
sprayer are as thin as water.
Make sure that all chemicals/
liquids used in the sprayer are as
thin as water.
Recharge the battery.
Make sure that all chemicals/
liquids used in the sprayer are as
thin as water.
7