Preparing For Use; Vacuum Dust Extraction; Dust Box For Internal Vacuum Extraction - Parkside PHS 160 B2 Instrucciones De Utilización Y De Seguridad

General safety advice for electrical power tools / Preparing for use
A lways work with the mains lead leading
away from the rear of the device.
D ANGER oF FIRE FRoM FLyING SPARKS!
Abrading metal creates flying sparks. For this
reason, always make sure that nobody is placed
in any danger and that there are no inflamma-
ble materials near the working area.
Any harmful / noxious dusts generated from
sanding represent a risk to the health of the
person operating the device and to anyone
near the work area.
sanding wood and in particular when working
on materials that give rise to dusts that are haz-
ardous to health, the sander must be connected
to a suitable external dust extraction device.
Wear protective glasses and a dust mask!
E nsure that there is adequate ventilation when
working on plastic, paint, varnish etc.
D o not soak the materials or the surface you
are about to work on with liquids containing
solvents.
D o not abrade moistened materials or damp
surfaces.
A void sanding paints containing lead or other
substances hazardous to health.
D o not work on materials containing asbestos.
Asbestos is a known carcinogen.
A void contact with the moving sanding sheet.
o perate the device only with an attached
sanding sheet.
N ever use the device for a purpose for which it
was not intended nor with non-original parts /
accessories. The use of tools or accessories
other than those recommended in the operating
instructions could lead to you suffering an injury.
S witch the device off and allow it to come to a
standstill before you put it down.
A lways keep the device clean, dry and free of
oil or grease.

Preparing for use

Q
CAUTIoN! Make sure that the device is switched
off before you connect it to the mains supply.
NoxIoUS FUMES!
DUST HAzARD! When
Note! Always switch on the delta sander before
bringing it into contact with the workpiece material.
Switching on the device:
Push the oN / oFF switch
Switching off the device:
Push the oN / oFF switch

Vacuum dust extraction

Q
DANGER oF FIRE! There is
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the
vacuum's dust bag) may ignite, e.g. as a result of
flying sparks generated when abrading metals or
metal objects left in wood. This can happen par-
ticularly if the wood dust is mixed with paint resi-
due or other chemicals and the abraded particles
are hot from prolonged abrasion. Therefore you
must empty the device's dust collection box and the
vacuum cleaner's dust bag before taking a break
or stopping work and always avoid overheating of
the abraded particles and the device.
Wear a dust mask!
Always pull the mains plug is
out of the socket before doing any work on the
device.
Dust box for internal
Q
vacuum extraction
Mounting:
Slide the dust box for self-generated dust ext-
raction up to the stop on the hand sander.
4b
Removal:
P ress the release button
box for internal vacuum extraction
withdraw it towards the rear of the device.
into Position "I".
8
into Position "0".
8
of the dust extraction
5
and
4b
GB/MT 25