Dr 5600 Desoldering Iron - jbc Advanced Serie Manual Del Usuario

We appreciate the trust you have placed in JBC by purchasing this DR 5600
desoldering iron. It has been manufactured with the strictest quality standards in
order to give you the best possible service.
Before using this equipment, we recommend you read these instructions carefully.

DR 5600 DESOLDERING IRON

Includes the following:
- DR 5600 desoldering iron ref. 5600000 with
the 5600-003 tip ref.5600003.
Power desoldering iron: 75W.
- Set of accessories ref. 0780593 with tips for
the desoldering iron: 5600-013, 5600-004 and
5600-005.
- Instructions manual.
This product should not be thrown in the
.
garbadge
DR 8500
desoldering iron
stand
Ref.0788500
External desoldering air filter
Ref.0821830
Heating element
DR 5600
desoldering iron
Ref.5600000
Vacuum inlet
Connector
Spare filters
Ref.0781046
Ref.5600010
The desoldering iron is connected to the station
following the below procedure:
Connect the cable connection from the
desoldering iron to the plug in the DR 8500
desoldering iron stand, connect the vacuum hose
to the external desoldering air filter, which is
connected to the vacuum connection of the
station. The cable connection of the desoldering
iron stand can be connected to any of the two
connectors at the back of the station. Very
important, it is essential to connect the mentioned
filter to prevent from damaging the vacuum pump.
Desoldering process
Use the tip model with a larger diameter than
the pad to be desoldered, so as to achieve
maximum aspiration and thermal efficiency.
1 Apply the desoldering iron tip so that the
component terminal penetrates within its
orifice.
2 When the solder liquefies, start gently to
rotate the desoldering tip so that the
component's terminal can be eased away
from the sides.
3 Press then, not before, the vacuum pump
push-button just long enough to aspirate
the solder.
1 2
After pressing the desoldering key there is a
slight delay until the self-contained vacuum
pump stops, this is to make sure that the
vacuum circuit is completely empty.
If any solder remains are left on any terminal
after attempting to desolder it, resolder it with
fresh solder and repeat the desoldering
operation.
1
ENGLISH
3