jbc Advanced Serie Manual Del Usuario página 4

ENGLISH
Solder tin deposit
Desoldering tip
Heating element
Tip care
- The largest rod that fits in the tip hole should
periodically be passed through in order to
clean the intake tube.
- To clean the tips, use the sponge included
with the stand and check it is slightly
moisted.
Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water) Only deionised water (car battery water)
should be used in order to wet the sponge should be used in order to wet the sponge
should be used in order to wet the sponge. should be used in order to wet the sponge should be used in order to wet the sponge
If normal water was to be used, it is very
likely that the tip will become dirty due to the
salts dissolved within the water.
- Do not file the tips or use abrasive tools
which may damage the tip's protective
surface coating and avoid knocking them
about.
- If the tip has been a long time without
being tinned, use a metal brush to remove
any dirt and oxid.
IMPORTANT: : : : : DO NOT press the pushbutton
vacuum pump while tinning the desoldering
tip, as the fumes given off by the flux would
quickly soil the ducts and filter of the air
circuit.
DR 5600 Ref.5600000
Metal
Glass
Pushbutton vacuum pump
2
Change of desoldering tip
This operation should be done while the tip is
hot, at a minimum temperature of 250°C, so
that any tin left inside is in molten state.
- Unscrew the tip to be replaced, with the aid
of the spanner supplied.
- Fit the new tip, and tighten up with the
spanner to achieve a good air tightness.
Vacuum hose
Desoldering iron cable
Ref. 0780550