INSTALLING THE GRASS CATCHER
(FOR REAR BAGGING OPERATION)
See Figure 4.
NOTE: When using the grass catcher, the mulching plug
must be removed.
Lift the rear discharge door.
Lift the grass catcher by its handle and place under the
rear discharge door so that the hooks on the grass catcher
are seated onto the groove on the mower housing.
Release the rear discharge door.
REINSTALLING THE MULCHING PLUG
(FOR MULCHING OPERATION)
See Figure 5.
NOTE: When using the mulching plug, do not install the
grass catcher.
Lift and hold the rear discharge door.
Grasp the mulching plug by its handle and insert it at a
slight angle, as shown. Push the mulching plug securely
into place.
Lower the rear discharge door.
INSTALLING THE SIDE DISCHARGE
DEFLECTOR (FOR SIDE DISCHARGE
OPERATION)
See Figure 6.
NOTE: For best results, always use the mulching plug when
using the side discharge.
Lift and hold the side discharge door.
Align the grooves on the deflector with the pins on the
underside of the door, then lower the deflector.
Release the deflector and door.
ASSEMBLY
SETTING BLADE HEIGHT
See Figure 7.
When shipped, the wheels on the mower are set to a low-
cutting position. Before using the mower for the first time,
raise the cutting position to the height best suited for your
lawn. The average lawn should be between 1-1/2 in. to 2 in.
during cool months and between 2 in. and 3-1/4 in. during
hot months.
WARNING:
Always set both front and rear height adjustments at the
same level. Failure to follow these instructions may result
in serious injury.
The front and rear wheels adjust separately. Be sure to set
the adjustment for the front and rear wheels at the same
height to ensure level cutting.
To adjust the blade height:
To raise the blade height, grasp the height adjustment
lever, pull toward you, and move it toward the center of
the mower deck.
To lower the blade height, grasp the height adjustment
lever pull toward you, and move it toward the front or
back of the mower.
Page 8 — English