Installatio Installatio; Din Front-Mount (Method A); Installing The Unit - Lenco CS-351 Modo De Empleo

INSTALLATION
INSTALLATION INSTALLATION INSTALLATION
Notes: Notes:
Notes: Notes:
�
Choose the mounting location where the
unit will not interfere with the normal
driving function of the driver.
�
Before finally installing the unit, connect
the wiring temporarily and make sure it is
all connected up properly and the unit and
the system work properly.
�
Use only the parts included with the unit
to ensure proper installation. The use of
unauthorized
malfunctions.
�
Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
�
Install the unit where it does not get in the
driver’s way and cannot injure the
passenger if there is a sudden stop, like
an emergency stop.
If installation angel exceeds 30 ° from
�
horizontal, the unit might not give its
optimum performance.
�
Avoid installing the unit where it would be
subject to high temperature, such as from
direct sunlight, or from hot air, from the
heater, or where it would be subject to
dust, dirt or excessive vibration.
DIN DIN FRONT/REAR-MOUNT FRONT/REAR-MOUNT
DIN FRONT/REAR-MOUNT DIN FRONT/REAR-MOUNT
This unit can be properly installed either
from "Front" (conventional DIN Front-mount)
or "Rear" (DIN Rear-mount installation,
utilizing threaded screw holes at the sides
of the unit chassis). For details, refer to the
following illustrated installation methods.
parts can cause
30
Take out screw
before installation.
DIN DIN FRONT-MOUNT FRONT-MOUNT
DIN FRONT-MOUNT DIN FRONT-MOUNT (Method
Installation Installation Opening Opening
Installation Opening Installation Opening
This unit can be installed in any dashboard
having an opening as shown below:
182mm
Installing Installing Installing Installing the the the the unit unit unit unit
Be sure you test all connections first, and
then follow these steps to install the unit.
1. Make sure the ignition is turned off, and
then disconnect the cable from the
vehicle battery's negative (-) terminal.
2. Disconnect the wire harness and the
antenna.
3. Press the release button on the front
panel and remove the control panel
(see the steps of "removing the front
panel").
4. Lift the top of the outer trim ring then pull
it out to remove it.
5. The two supplied keys release tabs inside
the unit’s sleeve so you can remove it.
Insert the keys as far as
3
(Method (Method A) A) A) A) (Method
53mm