User Instructions; Over Heat Protection - Easy Home TNP-2008I-E3 Manual Del Usuario

User instructions

How to use
1. Always operate the heater in the upright position while following all
recommendations and instructions listed in this manual.
2. Place the heater in an area of the room that is the coldest.
3. Plug into a compatible wall outlet. Be sure the plug fits tightly.
NOTE: To prevent overloading a circuit, do not plug the heater into a circuit that
other electrical appliances are plugged into.
Control Knob
•
LED flame effect only – turn control knob to FLAME ONLY setting.
Indicator light will come on.
•
LOW heat – turn control knob to LOW HEAT setting. The fan will come on
at full speed and heat will be limited to 700 watts.
•
HIGH heat – turn control knob to HIGH HEAT setting. The fan will come on
at full speed and heat will reach limit of 1200 watts.
•
OFF – turn control knob to OFF. The power indicator light will go off.

OVER HEAT PROTECTION

This heater is protected with an overheat protection that switches off the heater
automatically in case of overheating, ex: due to partial or total obstruction of
the main grids. In this case, unplug the heater for it to cool and remove any
obstruction. After 30 minutes, switch the heater back on and the heater should
operate normally. Should the problem persist, contact customer service.
8
SAVE ALL INSTRUCTIONS!
User instructions